20 October, 2021 | By Magnus Frejd |
I have a vintage washing machine that in the end tiny the dust, thus I’ve proceeded to try many projects using its stays. I want to try to make a mechanical chicken plucker making use of the bath and engine. I have taken apart and saved most of the of use areas and scrap metallic, but when it have down seriously to attempting to make the motor turn, I immediately acquired jammed. I am intending some body can aim me personally during the suitable direction.
Here you will find the standards: washer version: Whirlpool LA7800XP electric motor: c68pxefd-3454
These are some photographs of motor and wiring:
I’d considerably love any assistance/advice.
Answers and responds
- Sep 23, 2014
- Sep 23, 2014
Hi, Baluncore . thanks for the reply. Yes, there was come across that line before during my reports on the web. I accompanied the plan as meticulously as I could, but our situation’s a little bit different. There isn’t a block on the exterior as pictured from inside the thread, merely relaxed cables. Also, my own tones are wide and varied. Some tips about what I’ve carried out yet via learning from mistakes:
In this construction, I have power from the test contribute attached to the energy remove, straight into the capacitor. Next, from capacitor to electric motor by way of the yellow wire. White connects to basic back at my challenge run, and crushed goes toward the motor casing. Nowadays, while I hook up the alternative line operating while in the engine to natural, the engine spins. However, it spins very slowly (possibly 100 rpm or more), and after several seconds slows down extremely. Connecting the pink cable to neutral at once since eco-friendly cable is connected to basic makes no difference. Hooking up the pink line to basic without joining the green wire to neutral produces a hum, but no motion.
Any tips what you should take to beside have this to reel at full speed?